Prepared by GreaseTrapLocator · Fact review: October 15, 2026
Holiday menus can mean more frying, roasting and dishwashing in a commercial kitchen. This page is a pre-rush checklist built from published sewer-utility rules and guidance. It does not set a rule for your kitchen: your local sewer or pretreatment authority decides how often your grease trap or interceptor must be cleaned and which records you must keep. The examples below name the place each rule comes from, and they differ.
Why grease matters more when the kitchen is busy
EPA’s fact sheet for food service establishments quotes its report to Congress on sewer overflows, which found that grease from restaurants, homes and industrial sources was the most common cause (47%) of reported blockages. That figure comes from a 2004 EPA report; it is not a current national statistic. EPA also says grease is a problem because it solidifies, reduces pipe capacity and blocks flow. [1]
EPA says the maintenance a grease interceptor needs “depends greatly on the amount of FOG a facility generates” and on the kitchen’s best management practices. [1] Holiday cooking does not change your local rule, but more grease going into the system can mean the device fills sooner.
Several utilities run holiday grease reminders. The City of San Diego’s November 2025 release warned that cooking grease “can clog pipes” and lead to a sewer spill, and Austin Water says proper disposal is “especially important” during the holiday season. [2] [3] Both messages are aimed at home cooks. For commercial kitchens, the rules that apply are the year-round local rules described below.
Pre-rush checklist for commercial kitchens
1. Know your cleaning trigger and schedule
Cleaning rules are local, and they are not the same everywhere. Examples:
- Washington, DC (DC Water): gravity grease interceptors are to be cleaned and inspected every 90 days, or sooner if they become more than 25% full of grease and solids; hydromechanical interceptors every 30 days, or sooner if they become more than 50% full. [4]
- Austin, Texas (Austin Water): grease traps must be pumped at least once every 90 days, or sooner if grease and solids reach 50% of the wetted height. [5]
- Seattle (Seattle Public Utilities): businesses must clean interceptors when they are more than 25 percent full of grease and food waste. [6]
- Hampton Roads, Virginia (HRSD): gravity interceptors are to be pumped out completely at least every 90 days, or when grease and solids reach 25% of the liquid volume, whichever comes first. [7]
- Portland, Oregon: the City sets each interceptor’s cleaning frequency based on the type of establishment, the size of the interceptor and the volume of flow. [8]
Find the rule for your location through our state regulations pages and the FOG requirements by state tool, then confirm it with your local sewer authority.
2. Ask whether the rush changes your timing
Some local guidance says busy periods can call for earlier service. The Santa Cruz County Sanitation District’s restaurant guidance says that if “a heavy business period is encountered, you may need to have the unit cleaned earlier.” Western Water in California says “the busier the facility, the more frequent the cleaning.” [9] [10] Neither sentence ties this to a holiday, and neither is a rule outside its own area.
Look at your last service date and, if your records include it, how full the device was. If your next scheduled service falls during or just after your busiest weeks, ask your service provider and your local program whether earlier service makes sense. The cleaning schedule planner can help you lay out dates; it does not replace your local rule.
3. Plan where used fryer oil goes
DC Water tells food service establishments to “collect and recycle used cooking oil” and to store it in covered containers without overfilling. Orange County Sanitation District in California says to pour fryer oil into a covered grease container for recycling, use a permitted collection service or authorized recycler, and keep a log. [4] [11] HRSD says fryer oil (“yellow grease”) shall not be poured into any part of the sanitary sewer system. [7]
If you do not yet have a used-oil collector, the cooking oil recycling finder is a starting point.
4. Scrape and dry-wipe before washing
Portland’s business guidance says to “dry wipe” pots, pans and dishware into a trash container before rinsing and dishwashing. Orange County Sanitation District and DC Water give the same kind of instruction. [12] [11] [4]
5. Do not count on hot water, soap or a disposal
Austin Water’s household guidance says hot water and soap “may serve only to push the potential clog further down the pipe,” and that garbage disposals grind greasy food into smaller particles that can cling to pipes. [3] In its service area, Austin Water says food grinders and disposals have been prohibited in commercial kitchens since 2008. [5] The Santa Cruz County Sanitation District tells restaurants that a hot water flush “is not the answer” for plugged sinks and that the grease trap likely needs service. [9] Orange County Sanitation District says hot water over 140°F should not go down a drain connected to a grease trap or interceptor. [11]
6. Brief everyone who works the line
DC Water lists training new employees in kitchen best management practices, and Portland recommends posting “No Grease” signs above sinks and on dishwashers. [4] [12] The FOG compliance checklist can be used as a staff walkthrough.
7. Have your service records ready
Record rules vary. Austin requires the manifest records from each pump-out to be kept on site for three years. HRSD requires the most recent three years of cleaning and maintenance records to be available on site. Portland requires a cleaning report to be filed with the City after every cleaning or pump-out. [5] [7] [8] The waste manifest tracker can help you keep your own copies in one place.
8. Check the work after service
Austin Water advises being present for pump-outs and talking with the hauler about the percentage of grease and solids and the condition of the device. [5] For what to put in writing before the visit, see Grease Trap Pumping vs. Cleaning: Why the Terms Vary.
If drains back up during the rush
Use the grease trap overflow checklist and our guide Grease Trap Backup During Service: What to Do First. Follow your local program’s instructions for reporting a spill or overflow.
Finding a service company
You can search for grease trap service companies in our directory. GreaseTrapLocator lists companies; it does not vet, license or verify them. Before you book, check that the company holds any permit or registration your local program requires. Our guide How to Choose a Grease Trap Company lists what to check.
What this page does not establish
This page does not set a cleaning frequency for any kitchen, does not say that holiday cooking requires extra service anywhere, and does not replace your local sewer authority’s rules or permit conditions. The local examples above apply only in the places named.
Frequently asked questions
Do I have to pump my grease trap before Thanksgiving?
No source reviewed for this page sets a holiday-specific rule. Your local program sets the schedule. Some local guidance, such as the Santa Cruz County Sanitation District’s, says a heavy business period may mean cleaning earlier. [9]
Is there a national rule for how often to clean a grease trap?
Not in the sources reviewed here. EPA says maintenance frequency depends on how much grease a facility generates and its best management practices, and local programs set the rules. Examples include every 90 days, or sooner if more than 25% full of grease and solids, for gravity interceptors in Washington, DC, and 90 days or 50% of wetted height in Austin. [1][4][5]
Can we pour used fryer oil down the drain if we run hot water after it?
No program reviewed here allows it. HRSD says fryer oil shall not be discharged to any part of the sanitary sewer system, and Austin Water’s household guidance says hot water and soap may only push a clog further down the pipe. Collect used oil for recycling. [3][7]
How long should we keep grease trap service records?
It depends on your location. Austin requires pump-out manifests to be kept on site for three years, and HRSD requires the most recent three years of records to be available on site. Check your local rule. [5][7]
Does GreaseTrapLocator check the companies it lists?
No. GreaseTrapLocator lists companies but does not vet, license or verify them. Check any permit or registration your local program requires before booking.
Sources
- U.S. EPA, “Controlling Fats, Oils, and Grease Discharges from Food Service Establishments” (EPA-833-F-12-003, September 2012) (verified October 15, 2026). The 47% figure is EPA’s quotation of its 2004 report to Congress.
- City of San Diego Public Utilities, “Don’t Ruin Your Holiday Celebrations with a Clogged Sewer Line” (news release, November 25, 2025) (verified October 15, 2026). Aimed at residents.
- City of Austin, Austin Water, “Grease Blob” (verified October 15, 2026). Household guidance, including the holiday tips.
- DC Water, “Food Service Establishments & Compliance” (verified October 15, 2026). Washington, DC rules only.
- City of Austin, Austin Water, “Grease Trap Maintenance” (verified October 15, 2026). Austin Water service area only.
- Seattle Public Utilities, “Fats, Oils, & Grease: Commercial Kitchens” (verified October 15, 2026). Seattle rules only (SMC 21.16.310).
- Hampton Roads Sanitation District, “HRSD Fats, Oils and Grease Best Management Practice” (revision effective January 1, 2021) (verified October 15, 2026). HRSD service area only.
- City of Portland, Bureau of Environmental Services, “Grease Interceptors and How to Maintain Them” (verified October 15, 2026). Portland only.
- Santa Cruz County Sanitation District, restaurant best management practices handout (file dated 2016) (verified October 15, 2026). Local guidance only; an older document.
- Western Water (California), “Fats, Oils, & Grease Program” (verified October 15, 2026). Local guidance only.
- Orange County Sanitation District, “Kitchen Best Management Practices (BMPs) for Fats, Oils, and Grease (FOG)” (verified October 15, 2026). Orange County, California only.
- City of Portland, Bureau of Environmental Services, “Fats, Oil, and Grease Best Management Practices for Businesses” (verified October 15, 2026). Portland guidance.
Find local contractors who handle cleaning, pumping, and FOG compliance — in your area.
